Bridge/Router Installation Guide

4-53
Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-07
Chapter 4 Installing and Removing SFCs, RPs, MSCs, PLIMs, and Associated Components
How to Install or Remove a Small Form-Factor Pluggable (SFP) Module
Installing a Bale-Clasp SFP Module
This section describes how to install a bale-clasp SFP module. The module has a clasp used to install
and remove the module (see
Figure 4-32).
Figure 4-32 Bale-Clasp SFP Module
Prerequisites
Before installing a module, remove any front cover plates.
Required Tools and Equipment
You need the following tools and part to perform this task:
• ESD-preventive wrist strap
• Bale-clasp SFP module
Steps
To install a bale-clasp SFP module (into a PLIM), follow these steps:
Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
Step 2 Close the bale clasp before inserting the module.
Step 3 Align the module with the port and slide it into the port (see Figure 4-33).
Note Be careful to hold the module in such a way so as to not damage the bale clasp.
63067