User's Manual

Index
IN-10
ATM Switch Router Software Configuration Guide
OL-7396-01
testing 3-32
testing NVRAM 3-33
configure command
entering command mode
2-6
configuring
ATM addresses
3-5
BOOTP server 3-4
ESHA 5-11
Ethernet connections 3-7 to 3-9
IP address 3-7 to 3-9
IP QoS 22-11, 22-17
network clocking 3-10 to 3-18
network routing 3-18
prerequisites 3-2
RMON 3-23
SNMP 3-23, 15-20 to 15-24
system information 3-19
terminal line 3-2
configuring explicit paths
CES VC, overview
19-61
CES VC displaying 19-63
CES VC example 19-63
configuring interfaces
155 Mbps
18-4 to 18-5
25 Mbps 18-2 to 18-3
622 Mbps 18-6 to 18-8
ATM router module 25-2 to 25-11
CDS3 Frame Relay 20-2 to 20-6
CE1 Frame Relay 20-7 to 20-9
CES T1/E1 19-2 to 19-7
DS3 18-13 to 18-14
E1 ATM 18-15 to 18-17
E1 IMA 21-3 to 21-5
E1 trunk 18-15 to 18-17
E3 18-13 to 18-14
IISP 6-7
interface snooping 7-91, 7-98
methods 3-2
OC-12c 18-9 to 18-10
OC-3c 18-5 to 18-6
OC-48c 18-11 to 18-12
T1 ATM 18-15 to 18-17
T1 IMA 21-3 to 21-5
T1 trunk 18-15 to 18-17
terminal lines and modem support 4-1 to 4-2
troubleshooting connections 18-17
configuring LECs and 1483 PVCs 25-15
connection-category command 17-12
connection command, show sgcp 19-60
connections
Frame Relay
20-23 to 20-54
OAM 8-1 to 8-4
See also VCs
connection traffic table. See CTT
connection-traffic-table rows. See CTTRs
connection-types command
15-5
connectivity
checking
4-24
constant bit rate. See CBR
controlled link sharing
configuring
9-22
displaying configuration 9-23
minimum and maximum parameter relationships
(table)
9-22
controller command
entering command mode
2-15
controller configuration mode
description
2-15
table 2-5
controller e1 command
CE1 Frame Relay interfaces
20-8
channel groups 20-8
controller t3 command 20-3, 20-4
CoS
configuring for tag switching
16-13 to 16-16
port weight mappings (table) 16-13
VP tunnel weight mappings (table) 16-14
counters, route processor synchronizing 5-6