User's Manual

20-47
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 20 Configuring Frame Relay to ATM Interworking Port Adapter Interfaces
Configuring Overflow Queuing
• Disabled—Enabled
• Disabled—Disabled
• Disabled—Inherited
• Disabled—Not mentioned
• Inherited—Enabled
• Inherited—Disabled
• Inherited—Inherited
• Inherited—Not mentioned
• Not mentioned—Enabled
• Not mentioned—Disabled
• Not mentioned—Inherited
• Not mentioned—Not mentioned
Note In the previous list, “Not mentioned” equals the default.
Configuring Overflow Queuing on Frame Relay to ATM Soft PVCs
To configure overflow queuing for Frame Relay to ATM network interworking Soft PVC, perform the
following steps, beginning in EXEC mode:
Command Purpose
Step 1
Switch# show interfaces Determines source and destination interfaces.
Step 2
Switch# show vc interface serial
card/subcard/port:cgn [dlci]
Determines the DLCI_a switch available for
Step 7.
Step 3
Switch# show vc interface serial
card/subcard/port:cgn [dlci]
Determines the DLCI_b switch available for
Step 7.
Step 4
Switch# show atm addresses Determines soft PVC destination address.
Step 5
Switch# configure terminal
Switch(config)#
From the source (active) side, at the privileged
EXEC prompt, enter configuration mode from the
terminal.