Network Router User Manual

Contents
vii
ATM Switch Router Software Configuration Guide
OL-7396-01
Configuring RADIUS Server Communication 4-18
Configuring Secure Shell 4-19
Displaying and Disconnecting SSH 4-22
Testing the System Management Functions 4-23
Displaying Active Processes 4-23
Displaying Protocols 4-23
Displaying Stacks 4-23
Displaying Routes 4-24
Displaying Environment 4-24
Checking Basic Connectivity (Catalyst 8540 MSR) 4-24
Checking Basic Connectivity (Catalyst 8510 MSR and LightStream 1010) 4-24
CHAPTER 5 Configuring Redundancy 5-1
Route Processor Redundant Operation (Catalyst 8540 MSR) 5-1
Configuring Route Processor Redundancy (Catalyst 8540 MSR) 5-3
Forcing a Route Processor Switchover (Catalyst 8540 MSR) 5-3
Displaying the Configuration Register Value 5-5
Synchronizing the Configurations (Catalyst 8540 MSR) 5-5
Immediately Synchronizing Route Processor Configurations (Catalyst 8540 MSR) 5-6
Immediately Synchronizing Route Processor Counters (Catalyst 8540 MSR) 5-6
Synchronizing the Configurations During Switchover (Catalyst 8540 MSR) 5-6
Synchronizing the Dynamic Information (Catalyst 8540 MSR) 5-7
Configuring Dynamic Information Synchronization (Catalyst 8540 MSR) 5-7
Configuring Counter Synchronization (Catalyst 8540 MSR) 5-8
Displaying the Route Processor Redundancy Configuration (Catalyst 8540 MSR) 5-9
Preparing a Route Processor for Removal (Catalyst 8540 MSR) 5-10
Configuring Switch Fabric Enhanced High System Availability Operation (Catalyst 8540 MSR) 5-11
Configuring Preferred Switching Processors (Catalyst 8540 MSR) 5-12
Displaying the Preferred Switch Processor Redundancy Configuration
(Catalyst 8540 MSR)
5-12
Displaying the Switch Processor EHSA Configuration (Catalyst 8540 MSR) 5-13
Storing the Configuration 5-14
CHAPTER 6 Configuring ATM Network Interfaces 6-1
Disabling Autoconfiguration 6-1
Displaying the Autoconfiguration 6-2
Configuring UNI Interfaces 6-3
Displaying the UNI Interface Configuration 6-3