Universal Gateway Chassis Installation Guide

Index
IN-5
Cisco AS5350XM Universal Gateway Chassis Installation Guide
OL-6417-02
rear panel illustration (figure) 1-2
rear panel LEDs (figure) 4-1
reconnecting the power cables to the backplane
(figure)
B-10
regulatory compliance 1-5
removing and replacing the SDRAM DIMM (figure) A-7
removing the air separator (figure) B-7
removing the chassis cover A-1, B-2
removing the chassis cover (figure) A-3
removing the chassis cover screws (figure) A-3
removing the power supply mounting screws (figure) B-6
replacing memory components A-1
replacing SDRAM A-6
replacing the air separator (figure) B-11
replacing the chassis cover A-8, B-11
replacing the chassis cover (figure) A-9, B-12
replacing the compact flash A-4
replacing the fan tray 4-5
replacing the power supply, required tools B-2
required tools, rack-mounting 3-4
required tools, replacing the power supply B-2
required tools, SDRAM replacement A-6
rollover cable (figure) C-2
rollover cable, identifying C-2
S
Safety
general guidelines
2-1
with electricity 2-1
safety recommendations A-1
screws, loosen fan tray screws (figure) 4-6
SDRAM, replacing A-6
SDRAM replacement, required tools A-6
serial interfaces 1-4
serial ports, supported standards 2-5
service and support 4-10
setting up the chassis 3-1
single power supply 3-16
sliding fan tray out of slots (figure) 4-8
slot numbering (figure) 4-3
slot numbering, description 4-2
specifications, cabling C-1
specifications, Cisco AS5350 (table) 1-4
standard bracket installation (figure) 3-4
standard rack-mount brackets (figure) 3-4
static electricity, caution B-2
static electricity, preventing 2-2
support, getting technical 4-10
supported standards, serial ports 2-5
Symbols
Caution
viii
Note viii
Timesaver viii
Tips viii
system board (figure) A-5
T
T1 card, connections 3-7
Tables
10BASE-T Port Pinouts
C-4
Alarm Port Pinouts C-5
Auxiliary Port Signaling and Cabling using a DB-25
Adapter
C-4
Bantam Jack Port Pinouts C-5
BITS Port Pinouts C-5
Chassis LEDs 4-2
Chassis Specifications 1-4
Console Port Signaling and Cabling Using a DB-25
Adapter
C-3
Console Port Signaling and Cabling using a DB-9
Adapter
C-3
Organization vii
technical support 4-10
temperature, monitoring 4-2
temperature specification 1-4
tightening fan tray screws (figure) 4-10