Universal Gateway Chassis Installation Guide

B-8
Cisco AS5350XM Universal Gateway Chassis Installation Guide
OL-6417-02
Appendix B Replacing the Power Supply
Removing the Old Power Supply
Figure B-8 Power Supply Connectors
Step 5
Disconnect both power supply connectors. Disconnect the backplane connector first, followed by the
system board connector. (See Figure B-9.)
Note The system board connector is located on the system board, below and to the left of the
backplane connector.
Figure B-9 Disconnecting the Power Connectors from the Backplane
Step 6
Slide the power supply toward the front panel to disengage the power supply from the chassis hooks.
(See Figure B-10.) Remove the power supply from the chassis.
Power
supply
Backplane
connector
System board
connector
36016
Power
supply
35693
3
Chassis bottom
Front panel
Power connector
Backplane