Universal Gateway Chassis Installation Guide

3-8
Cisco AS5350XM Universal Gateway Chassis Installation Guide
OL-6417-02
Chapter 3 Installing the Cisco AS5350XM Universal Gateway
Connecting to the Network
Figure 3-7 Connecting a 2-Port or 4-Port DFC to an RJ-45 (T1) Jack
Figure 3-8 Connecting an 8-Port DFC to an RJ-45 (T1) Jack
Note Use software commands to choose a specific port and the line termination on that port. For information
about software commands, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways
Software Configuration Guide. This document is available on Cisco.com. (See the “Obtaining
Documentation” section on page xiv.)
Note If you choose a port with 75-ohm input impedance, use an RJ-45-to-75-ohm coaxial cable adapter and
plug it into that port.
35672
RJ-45 jack
Straight-through
RJ-45-to-RJ-45 cable
56057
T1/E1 8 PRI
connector
RJ-45 jack
P
1
P
2
P
3
P
4
P
5
P
6
P
7
P
0
Straight-through
RJ-45-to-RJ-45 cable