Universal Gateway Chassis Installation Guide

3-6
Cisco AS5350XM Universal Gateway Chassis Installation Guide
OL-6417-02
Chapter 3 Installing the Cisco AS5350XM Universal Gateway
Connecting to the Network
Figure 3-5 Cisco AS5350XM Universal Gateway Ground Lug Attachment
Connecting to the Network
This section describes how to connect the Cisco AS5350XM universal gateway to your network. The
cables required to connect the universal gateway to a network are not provided. For ordering information,
contact customer service. See the “Obtaining Technical Assistance” section on page xvii, or see
Appendix C, “Cabling Specifications,” for cable and port pinouts.
Warning To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Caution If the universal gateway is configured with fewer than three DFCs, make sure that a blank slot cover is
installed over each open slot to ensure proper airflow.
Note The Cisco AS5350XM universal gateway arrives with all carrier cards and DFCs already installed,
unless you order a card separately as a spare. See the Cisco AS5350XM and Cisco AS5400XM Universal
Gateways Card Installation Guide for card installation instructions. This document is available on
Cisco.com. (See the “Obtaining Documentation” section on page xiv.)
Connecting to an Ethernet Network
Connect an Cisco AS5350XM universal gateway Gigabit Ethernet port to an Ethernet hub using a
straight-through, RJ-45-to-RJ-45 Ethernet cable. (See Figure 3-6.)
82735
Ground lug
attachment