Network Router User Manual

12
Power
Warning Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning This equipment must be externally grounded using a customer-supplied ground wire
before power is applied. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 366
Warning Do not work on the system or connect or disconnect cables during periods of lightning
activity. Statement 1001
Caution Do not place the power injector in an unprotected outdoor environment because water
could get into the power injector and cause a short circuit and possible fire.
The access point supports the following power sources:
• Power-over-Ethernet—1520 power injector
• AC power—100 to 480 VAC
• Quazi-AC power-over-cable (POC)—40 to 90 V
• External 12 VDC power
4 No connection 2.4-GHz receive only
5 No connection No connection
6 No connection 2.4-GHz transmit and receive
Table 2 Antenna Ports and Configurations (continued)
Antenna Port
Product Configuration
Cable Strand Mount
(Two Antenna Receive MRC Access and
One Backhaul)
Pole Mount
(Three Antenna Receive MRC Access and
One Backhaul)