User's Manual

8-17
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-23091-01
Chapter 8 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phones
Status Menu
Procedure
Step 1 Verify that the phone is unlocked.
When options are inaccessible for modification, a locked padlock icon appears on the configuration
menus. When options are unlocked and accessible for modification, an unlocked padlock icon
appears on these menus.
To unlock or lock options on the Settings menu, press **# on the phone keypad. This action either locks
or unlocks the options, depending on the previous state.
Note If a Settings Menu password has been provisioned, SIP Phones present an “Enter password”
prompt after you enter **#.
Make sure to lock options after you have made your changes.
Caution Do not press **# to unlock options and then immediately press **# again to lock options. The phone
will interpret this sequence as **#**, which will reset the phone. To lock options after unlocking them,
wait at least 10 seconds before you press **# again.
Step 2 While offhook, press the Help button twice to invoke the Call Statistics screen, or press Settings >
Status > Call Statistics to invoke the Call Statistics screen. Look for the Tone softkey.
When the Tone softkey is visible, the softkey remains enabled for as long as this Cisco Unified IP Phone
is registered with Cisco Unified Communications Manager.
You can proceed to the procedure for using the tone generator.
Step 3 If the Tone softkey is not present, exit the Call Statistics screen and enter the Setting Menu. Press **3
on the phone keypad to enable (toggle) the Tone softkey.
Note If you press **# **3 consecutively, with no pause, you will inadvertently reset the phone
because of the **#** sequence. Make sure that you wait at least 10 seconds after you press **#
before you press **3.
While offhook, press the Help button twice to invoke the Call Statistics screen, or press Settings >
Status > Call Statistics to invoke the Call Statistics screen. Verify that the Tone softkey is present.
When the Tone softkey is visible, the softkey remains enabled for as long as this Cisco Unified IP Phone
is registered with Cisco Unified Communications Manager.
To use the tone, follow these steps:
Procedure
Note When measuring echo, make sure you first set the input and output levels to 0 dB gain/attenuation on
the trunk. This is set for the gateway (in Cisco Unified Communications Manager for MGCP) or under
IOS CLI for H.323 or SIP.
Step 1 Place a call.