User's Manual

4-31
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-23091-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phones
Device Configuration Menu
Ethernet Configuration Menu
The Ethernet Configuration menu includes the options that are described in Table 4-16.
Enterprise Advertise
G.722 Codec
Enables/disables Cisco Unified IP Phones to
advertise the G.722 codec to Cisco Unified
Communications Manager.
For more information, see the Cisco Unified
Communications Manager System Guide,
Cisco
Unified IP Phones.
Note When a phone is registered with a Cisco
Unified Communications Manager that
does not support this setting, the default
is Disabled.
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.
Device Advertise
G.722 Codec
Allows you to override the Enterprise Advertise
G.722 Codec on a per-phone basis.
Default: Use System Default, which means the
value configured for the Enterprise Advertise
G.722 Codec parameter gets used.
From Cisco Unified Communications Manager
Administration, choose Device > Phone.
Table 4-15 Media Configuration Menu Options (continued)
Option Description To Change
Ta b l e 4-16 Ethernet Configuration Menu Option
Option Description To Change
Forwarding Delay Indicates whether the internal switch begins
forwarding packets between the PC port and
switched port on the phone when the phone
becomes active.
• When forwarding delay is set to disabled, the
internal switch begins forwarding packets
immediately.
• When forwarding delay is set to enabled, the
internal switch waits eight seconds before
forwarding packets between the PC port and
the switch port.
Default is disabled.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Span to PC Port Indicates whether the phone will forward packets
transmitted and received on the network port to
the access port.
Enable this option if an application that requires
monitoring of the phone’s traffic is being run on
the access port. These applications include
monitoring and recording applications (common
in call center environments) and network packet
capture tools that are used for diagnostic purposes.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.