Getting Started Guide
Table Of Contents
- Cisco Catalyst 9130AX Series Access Points
- 1 About this Guide
- 2 About the Cisco Catalyst 9130AX Series Wireless Access Point
- 3 Safety Instructions
- 4 Unpacking
- 5 AP Views, Ports, and Connectors
- 6 Preparing the AP for Installation
- 7 Installation Overview
- 8 Performing a Pre-Installation Configuration
- 9 Mounting the Access Point
- 10 Grounding the Access Point
- 11 Powering the Access Point
- 12 Configuring and Deploying the Access Point
- 13 Self-Identifying Antennas
- 14 Checking the Access Point LEDs
- 15 Miscellaneous Usage and Configuration Guidelines
- 16 FAQs
- 18 Declarations of Conformity and Regulatory Information
- 17 Related Documentation
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Catalyst Access Points in Japan
- Statement 371—Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Generic Discussion on RF Exposure
- This Device Meets International Guidelines for Exposure to Radio Waves
- This Device Meets FCC Guidelines for Exposure to Radio Waves
- This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves
- Cet appareil est conforme aux directives internationales en matière d'exposition aux fréquences radioélectriques
- Additional Information on RF Exposure
- Administrative Rules for Cisco Catalyst Access Points in Taiwan
- Operation of Cisco Catalyst Access Points in Brazil
- Declaration of Conformity Statements
- Communications, Services, and Additional Information
- Cisco Bug Search Tool
30
Cisco Catalyst 9130AX Series Access Points
14 Checking the Access Point LEDs
The location of the access point status LED is shown in Figure 1.
Note Regarding LED status colors, it is expected that there will be small variations in color intensity and hue from
unit to unit. This is within the normal range of the LED manufacturer’s specifications and is not a defect.
However, the intensity of the LED can be changed through the controller.
The access point status LED indicates various conditions and are described in Table 3. The LED status is also indicated
by the C-ANT91xx antennas.
15 Miscellaneous Usage and Configuration Guidelines
Using the Mode Button
Using the Mode button (see Figure 2) you can:
Reset the AP to the default factory-shipped configuration.
Clear the AP internal storage, including all configuration files.
To use the mode button, press, and keep pressed, the mode button on the access point during the AP boot cycle. Wait
until the AP status LED changes to Blue. During this, the AP console shows a seconds counter, counting the number of
seconds the mode button is pressed. Then:
To reset the AP to the default factory-shipped configuration, keep the mode button pressed for less than 20
seconds. The AP configuration files are cleared.
This resets all configuration settings to factory defaults, including passwords, WEP keys, the IP address, and the
SSID.
To clear the AP internal storage, including all configuration files and the regulatory domain configuration, keep the
mode button pressed for more than 20 seconds, but less than 60 seconds.
The AP status LED changes from Blue to Red, and all the files in the AP storage directory are cleared.
Table 3 LED Status Indications
Message Type LED State Message Meaning
Association status Green Normal operating condition, but no
wireless client associated
Blue Normal operating condition, at least one
wireless client association
Boot loader status Green Executing boot loader
Boot loader error Blinking Green Boot loader signing verification failure
Operating status Blinking Blue Software upgrade in progress
Alternating between Green and
Red
Discovery/join process in progress
Cycling through
Red-Off-Green-Off-Blue-Off
Access point location command invoked
from controller web interface.
Access point operating
system errors
Cycling through
Blue-Red-Green-Off
General warning; insufficient inline power