Network Router User Manual

Copyright © 1999-2005 Go2Call.com, Inc. and/or its suppliers. All rights reserved. “Go2Call” and all associated logos are trademarks, registered as applicable, of Go2Call.com, Inc., and may not be reproduced without Go2Call’s permission. Other product
and company names herein may be the trademarks of their owners. This document is provided “as-is” by Go2Call.com, Inc. for the user’s internal and non-commercial use. Go2Call.com, Inc. does not promise that the information herein is accurate or
complete and all use of such information is solely at the user’s risk. All warranties disclaimed.
page 4 of 4
Cisco 827-4V Gateway Conguration
With Go2Call Prepaid Voice Service
Continued:
dial-peer voice 1 pots
port 1
!
dial-peer voice 2 pots
port 2
!
dial-peer voice 3 pots
port 3
!
dial-peer voice 4 pots
port 4
!
dial-peer voice 100 voip
destination-pattern 723
session protocol sipv2
session target ipv4:216.52.153.209
dtmf-relay rtp-nte
codec g723r63 byte 48
exit
!
gateway
exit
Exit and save the settings:
R1(cong-t)# ^Z
R1# write mem
STEP 6 Review the Conguration
You will see the entire router conguration. Verify it with the above cong.
R1# show run
Pick up the phone connected to P1 to P4 port and make a call:
For the USA and Canada dial: 1 + phone_number
For any other country dial: 011 + country_code + phone_number