Network Router User Manual

Copyright © 1999-2005 Go2Call.com, Inc. and/or its suppliers. All rights reserved. “Go2Call” and all associated logos are trademarks, registered as applicable, of Go2Call.com, Inc., and may not be reproduced without Go2Call’s permission. Other product
and company names herein may be the trademarks of their owners. This document is provided “as-is” by Go2Call.com, Inc. for the user’s internal and non-commercial use. Go2Call.com, Inc. does not promise that the information herein is accurate or
complete and all use of such information is solely at the user’s risk. All warranties disclaimed.
page 3 of 4
Cisco 827-4V Gateway Conguration
With Go2Call Prepaid Voice Service
STEP 5 Enabling VoIP
To enable VoIP, copy and paste the following output once you are in cong-t mode: R1(cong-t)#. These
are the changes that need to be made:
YourGwName ßReplace with your Gateway name or Company name.
12345678900x ßReplace with your PIN number.
X.X.X.X ßReplace with your IP address from the Ethernet port.
** If your Cisco 827-4v has a public ip address then use:
session target ipv4: 216.52.153.209
** If your Cisco 827-4v is behind NAT (has private IP address) then use:
session target ipv4: 216.52.153.217
Here is the list of the private IP addresses on the Internet:
10.0.0.0 - 10.255.255.255
172.16.0.0 - 172.31.255.255
192.168.0.0 - 192.168.255.255
Go through and make the necessary changes, as indicated in red:
voice-port 1
connection plar 723
station-id number 123456789001  Change with your PIN
!
voice-port 2
connection plar 723
station-id number 123456789002  Change with your PIN
!
voice-port 3
connection plar 723
station-id number 123456789003  Change with your PIN
!
voice-port 4
connection plar 723
station-id number 123456789004  Change with your PIN
!