Network Router User's Manual

LANE Configuration Examples
ATMSwitch Router Quick Software Configuration Guide4-16
LE Client ATM0.1 ELAN name: eng_elan Admin: up State: operational
Client ID: 1 LEC up for 1 hour 34 minutes 46 seconds
ELAN ID: 0
Join Attempt: 1
HW Address: 00e0.4fac.b402 Type: ethernetMax Frame Size: 1516
ATM Address: 47.00918100000000E04FACB401.00E04FACB402.01
VCD rxFrames txFrames Type ATM Address
0 0 0 configure
47.00918100000000E04FACB401.00E04FACB405.00
87 1 2 direct
47.00918100000000E04FACB401.00E04FACB403.01
90 2 0 distribute
47.00918100000000E04FACB401.00E04FACB403.01
91 0 95 send
47.00918100000000E04FACB401.00E04FACB404.01
94 42 0 forward
47.00918100000000E04FACB401.00E04FACB404.01
ATM_Switch# ping 172.16.0.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.0.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/202/1000
ms
ATM_Switch# ping 172.16.0.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.0.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/202/1000
ms
ATM_Switch#
Confirming Connectivity between the ATM Switch Router and the Routers
The following example shows how to use the ping command to confirm the connection
between the ATM switch router and routers:
ATM_Switch# ping 172.16.0.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.0.1, timeout is 2 seconds:
!!!!!