Network Router User's Manual

Configuring SVCs
ATM Switch Router Quick Software Configuration Guide3-2
If the SVC terminates on a router, however, configuration is required on the router where
the SVC terminates. For your convenience, the router configuration is described in this
section.
Figure3-1 shows an example network that illustrates how to set up SVCs. This example
network is used throughout this section.
Figure3-1 Example Network for Configuring SVCs
Configuring the Router
Perform the following tasks on both routers that terminate the SVC:
• Configure PVCs for QSAAL and ILMI signaling
• Configure IP and ESI addresses and subnet masks
• Determine the NSAP address
• Configure a map group and map list
The following subsections describe these procedures in detail.
Tips Open two Telnet windows for both the source and destination routers.