Network Router User's Manual

CHAPTER

Using the Command-Line Interface 1-1

Using the Command-Line

Interface

This chapter describes what you need to know about the Cisco IOS software (the software

that runs the ATM switch router) before you begin to configure it, and includes the

following sections:

• Getting Help

• Understanding Command Modes

• Understanding Interface Numbering

• Undoing a Command or Feature

• Displaying the Configuration

• Saving Configuration Changes

Understanding these concepts will save you time later on. If you have never used the

Cisco IOS software or need a refresher, take a few minutes to read this chapter before you

proceed to the next chapter.

If you are already familiar with the CiscoIOS software, skip this chapter and proceed to the

next chapter, “Getting Started.”

Note This document assumes you have already connected all necessary external devices

to the ATM switch router and configured your PC terminal emulation program for

9600baud, 8 data bits, no parity, and 2 stop bits.