Network Router User Manual

Chapter 3 Managing ITP Networks Using SGM
Connecting to a New Server
3-400
Cisco Signaling Gateway Manager User Guide
78-15589-01
To connect the client to a new server:
Step 1 (Optional) If you want to determine the default host name before you connect to
the new server, it is contained in the SERVER_NAME entry in the
System.properties file:
• If you installed SGM in the default directory, /opt, then the location of the
System.properties file is /opt/CSCOsgm/properties/System.properties.
• If you installed SGM in a different directory, then the System.properties file
is located in that directory.
Step 2 Select File > Connect to New Server from the SGM Main Menu. SGM displays
the Connect to New Server Dialog (Figure 3-93).
Figure 3-93 Connect to New Server Dialog
Step 3 Enter the name of the new server, or its IP address, in the Server Name or IP
Address field.
Step 4 Enter the SGM Naming Server UDP port number for the new server in the Name
Server Port field. The default value is 44742.
Step 5 Click OK. SGM stops the SGM client, then restarts the client connected to the
new server.