Network Router User Manual

3-121
Cisco Signaling Gateway Manager User Guide
78-15589-01
Chapter 3 Managing ITP Networks Using SGM
Working with Nodes
• Release 4 Trap Settings—Indicates whether the following ITP release
12.2(4)MB10 trap settings are enabled:
– Linkset State Change
– Link State Change
– Link Congestion State Change
– Link Receive Utilization Change
– Link Send Utilization Change
– Route Destination State Change
– Route Mgmt. State Change
– Route Table Load
– GTT MAP State Change
– GTT Table Load
– ASP Congestion Change
– SGMP Congestion Change
This column might not be displayed if the ITP does not support ITP release
12.2(4)MB10 traps.
• IP Address—IP address of a host to which the node sends traps.
• Port—Port to which the node sends traps.
• Trap Version—Trap version sent to this IP address and port.
• Community String—SNMP community name used by the node for read
access to the information maintained by the SNMP agent on the ITP.
Viewing CPU Statistics for a Node
SGM enables you to display the CPU utilization percentage for a node as a
function of time. SGM displays one CPU Utilization Percentage chart for each
active Route Switch Processor (RSP) CPU.
To display CPU Utilization Percentage charts for a node, right-click a node in a
window, then select View > Real-Time Data and Charts from the right-click
menu. (This option is available only if SGM can poll the node.) SGM displays the
SGM Real-Time Statistics: CPU Statistics window (Figure 3-26).