User Guide

Chapter 2 Basic MSFC Software Configuration
Configuring the MSFC2
2-8
Cisco 7600 Optical Services Router Quick Software Configuration Guide
78-12799-01
Specify the IGRP autonomous system number as follows:
Configure IP? [yes]: yes
Configure IGRP routing? [yes]: yes
Your IGRP autonomous system number [1]: 199
Step 8 Enter yes or no to the following query to accept or refuse Simple Network
Management Protocol (SNMP) management:
Configure SNMP Network Management? [yes]:
Community string [public]:
Note SNMP is the most widely supported standard for managing networks.
SNMP provides a means to access and set configuration and run-time
parameters and to monitor and control network elements for routers
and communication servers.
Step 9 Enter yes or no to the following query to accept or refuse Connectionless Network
Service (CLNS) management:
Configure CLNS? [no]: yes
CLNS router tag [area_1]:
CLNS domain [49]:
CLNS area [0001]:
CLNS station id [0027.25E9.B640]:
Note CLNS is an Open System Interconnection (OSI) layer service that
does not require a circuit to be established before transmitting data.
On completion of this procedure, you have successfully established the router’s
global configuration parameters.
Sample Display of Global Parameters
The following sample display lists the global parameters that you entered in
Step 3 through Step 10 in the preceding section.
The display indicates the order in which the parameters and their defaults appear
on your console terminal.