User Guide

Chapter 2 Basic MSFC Software Configuration
Configuring the MSFC2
2-6
Cisco 7600 Optical Services Router Quick Software Configuration Guide
78-12799-01
This display shows that no interfaces have been configured:
Interface IP-Address OK? Method Status Protocol
Ethernet0 unassigned YES unset administratively down down
POS3/0 unassigned YES unset administratively down down
POS3/1 unassigned YES unset administratively down down
POS3/2 unassigned YES unset administratively down down
POS3/3 unassigned YES unset administratively down down
ATM4/0 unassigned YES unset administratively down down
The following sample display results from a yes response to the current interface
summary query that is entered while you use the setup command.
This display shows that some interfaces have already been configured:
Interface IP-Address OK? Method Status Protocol
Ethernet0 3.3.1.1 YES NVRAM up up
POS3/0 2.1.1.1 YES NVRAM up up
POS3/1 2.1.1.2 YES NVRAM up up
POS3/2 2.1.1.3 YES NVRAM up up
POS3/3 2.1.1.4 YES NVRAM up up
ATM4/0 1.1.1.2 YES NVRAM up up
Step 3 Select the protocols that you intend to support for your network interfaces.
For IP-only installations, you can accept the default values for most of the
questions.
A typical minimum configuration procedure using IP follows and continues
through Step 8:
Configuring global parameters:
Enter host name [Router]: Router
Step 4 Enter the enable secret password when prompted to do so:
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter enable secret [<Use current secret>]: barney
For future use, make a note of this password.