User Guide

2-5

Cisco 7600 Optical Services Router Quick Software Configuration Guide

78-12799-01

Chapter 2 Basic MSFC Software Configuration

Configuring the MSFC2

Bridging software.

X.25 software, Version 3.0.0.

TN3270 Emulation software.

1 POS controller (4 POS).

1 Virtual Ethernet/IEEE 802.3 interface(s)

4 Packet over SONET network interface(s)

509K bytes of non-volatile configuration memory.

16384K bytes of Flash internal SIMM (Sector size 512K).

Configuration register is 0x2102

Note The first two sections of the above configuration script (containing the

banner screen and the installed hardware listing) appear only at initial

system startup. On subsequent uses of the setup command facility, the

setup script begins with the following system configuration dialog.

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Continue with configuration dialog? [yes/no]: yes

Enter yes when queried if you want to continue with the configuration

dialog.

Note The examples in this section represent a continuation of the console display

for the setup facility or the setup command.

Step 2 Enter yes when asked if you want to enter the initial configuration dialog and if

you want to see the current interface summary:

Would you like to enter the initial configuration dialog? [yes]: yes

First, would you like to see the current interface summary? [yes]: yes

Pressing Return in either case accepts the default response [yes].

The following sample display results from a yes response to the current interface

summary query that is entered while you are using the setup facility.