User Guide

Chapter 2 Basic MSFC Software Configuration
Performing Other Configuration Tasks
2-28
Cisco 7600 Optical Services Router Quick Software Configuration Guide
78-12799-01
After the interface configuration information is displayed, the user EXEC mode
prompt appears:
Router>
Step 10 Enter the enable command at the user EXEC mode prompt to enter the privileged
EXEC mode:
Router> enable
Router#
Step 11 Enter the show start-up config command at the privileged EXEC mode prompt
to display the enable password in the configuration file:
Router# show start-up config
.
.
.
Step 12 Enter the configure terminal command at the privileged EXEC mode prompt to
enter the global configuration mode:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Step 13 Change the software configuration register setting back to its original value.
Alternatively, change this value to 0x0102 (the factory default) by entering the
config-register value command:
Router(config)# config-register 0xvalue
Router(config)#
Step 14 Exit the global configuration mode by pressing Ctrl-Z or entering the end
command.
Router(config)# end
Router#
Step 15 Reboot the router and enable it using the recovered password.