User Guide

2-15
Cisco 7600 Optical Services Router Quick Software Configuration Guide
78-12799-01
Chapter 2 Basic MSFC Software Configuration
Verifying the Running Configuration Settings
Step 4 Save your configuration settings, as described in the “Saving the Running
Configuration Settings to NVRAM” section on page 2-19.
Your router is now minimally configured and able to boot using the currently
established configuration information.
To display a list of the configuration commands available to you, enter a question
mark (?) at the global configuration mode prompt (Router (config)#).
Verifying the Running Configuration Settings
You may want to verify the running configuration settings or any changes made
to the running configuration settings before they are saved. To do so, enter the
show running-config command at the privileged EXEC mode prompt.
Typical output from this command is shown in the following sections:
• Example of Running Configuration Settings for a Gigabit Ethernet WAN
Interface, page 2-15
• Example of Running Configuration Settings for an OC-3 POS Interface,
page 2-16
• Example of Running Configuration Settings for OC-12 POS Interface,
page 2-17
• Example of Running Configuration Settings for OC-12 ATM Interface,
page 2-18
ExampleofRunningConfigurationSettingsforaGigabitEthernet
WAN Interface
The show running-config command typically displays the following output for
an OC-3c/STM-1c POS interface installed in slot 7:
Router# show running-config
Building configuration...
Current configuration :2381 bytes
!