User Guide

Chapter 2 Basic MSFC Software Configuration
Configuring the MSFC2
2-12
Cisco 7600 Optical Services Router Quick Software Configuration Guide
78-12799-01
Answer yes if you want to save the running configuration file to NVRAM and
display the following additional output:
Use this configuration? [yes/no]: yes
[OK]
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
After you press Return, the system reverts to the user EXEC prompt:
Router>
Answer no to the configuration query to return to the privileged EXEC mode
prompt (Router#). You must reenter the setup command and enter the appropriate
modules configuration information.
When you complete this procedure, you have manually configured the global
system parameters and the network interface parameters using the setup facility
or the setup command. Your Gigabit Ethernet, POS, and ATM interfaces are now
available for limited use.
If you want to modify the currently saved configuration information (after you
complete the preceding procedure), enter the setup command at the privileged
EXEC mode prompt (Router#) at any time.
To perform more complex configuration tasks, you can enter the configure
command at the privileged EXEC mode prompt (Router#), which establishes the
global configuration mode [Router(config)#]. This mode is described in the
“Using the Global Configuration Mode” section on page 2-14.
Checking the IOS Software Version Number and the Installed
Interfaces
To determine the current Cisco IOS software version running on the MSFC2 in
the Cisco 7600 OSR, enter the show version command at the user EXEC prompt
(Router>).
This command displays the Cisco IOS version number and other information,
including the hardware installed in the system, the names and sources of system
image files, and the contents of the software configuration register.