User Guide

4 Cisco 7513 and Cisco 7576 Cable-Management Bracket Installation Instructions

Installing the Cable-Management Bracket

Step 2 Use a ﬂat-blade screwdriver to loosen the two slotted screws approximately 1/8-inch.

Step 3 Place the bracket over the screws (see Figure 2), and slide the bracket to the right.

Step 4 Use a ﬂat-blade screwdriver to tighten the screws.

Step 5 When installing the network interface cables, route the cables up to and through the

cable-management bracket. If you are using very thin cables that slip through the bracket

openings, insert nylon cable ties through the holes in the bracket and wrap them around

the cables to secure them.

Route the excess cable out through either end of the bracket, coil it, and secure it to the

rack using nylon cable ties or some other mode of attachment.

It might be necessary to bundle longer cables to avoid tangling them. Do this at the

cable-management bracket or at the rack, but leave enough slack in the cables to remove

processor modules and change cables as required. Also, do not block the power supply

air vents with cables.

This completes the procedure for installing the cable-management bracket.