User Guide

Cisco 7513 and Cisco 7576 Cable-Management Bracket Installation Instructions 3
Tools and Equipment Required
Tools and Equipment Required
You need the following tools and parts to install the cable-management brackets; the brackets and
panhead screws are included with the chassis:
• Large flat-blade screwdriver
• One cable-management bracket and two slotted panhead screws (already attached to the chassis)
Installation Procedure
To install the cable-management bracket, follow these steps:
Step 1 On the interface processor end of the chassis, locate the two slotted screws positioned
below the blower module and above the card cage. (See Figure 2.)
Figure 2 Cable-Management Bracket