Installation Manual

CHAPTER
Send documentation comments to [e-mail].
2-1
Cisco Nexus 6000 Series Hardware Installation Guide
OL-15902-01
2
Installing the Cisco Nexus 6000 Series Switches
This chapter describes how to install the Cisco Nexus 6004 switch. This chapter includes the following
sections:
• Preparing for Installation, page 2-2
• Installing the Switch, page 2-5
• Grounding the Switch, page 2-7
• Starting the Switch, page 2-12
Note Before you install, operate, or service the system, see the Regulatory, Compliance, and Safety
Information for the Cisco Nexus 6000 Series, Cisco Nexus 5000 Series, Cisco Nexus 3000 Series, and
Cisco Nexus 2000 Series for important safety information.
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning Only trained and qualified personnel must be allowed to install, replace, or service this equipment.
Statement 1030
Note Each new switch requires a license. For information on licensing, see the Cisco NX-OS Licensing Guide.