Switch User Manual

Chapter 1 Module Overview and Specifications
Gigabit Ethernet Switching Modules
1-38
Catalyst 4500 Series Module Installation Guide
78-13267-06
WS-X4524-GB-RJ45V
The WS-X4524-GB-RJ45V 24-port IEEE 802.3af-compliant PoE
10/100/1000BASE-T RJ-45 switching module (see Figure 1-35) has the following
specifications:
Figure 1-35 WS-X4524-GB-RJ45V 24-Port IEEE-Compliant PoE 10/100/1000BASE-T Switching Module
To provide PoE with the 24-port PoE 10/100BASE-TX switching module in a
Catalyst 4006 switch, you must have a power entry module (PEM) and a power
shelf installed. The Catalyst 4006 switch can provide 312 W per PoE module to
powered devices. If the powered devices are using the maximum 15.4 W per port,
there is only enough power for 18 powered devices. If the powered devices are
using less than 15.4 W per port, more powered devices can be powered, up to the
312 Watt maximum. For more information about installing the PEM or the
external power shelf, refer to the Catalyst 4000 Series Installation Guide,
Catalyst 4500 Series Installation Guide, Installation and Configuration Note for
the Catalyst 4500 Series AC Power Shelf, or the Catalyst 4500 Series Power Entry
Module and External Power Shelf Installation Note.
Specification Description
Module type 10/100/1000BASE-T Fast Ethernet switching module
with IEEE802.3af PoE
Port duplex mode Half or full duplex mode
Port speed 10, 100, or 1000 Mbps
Number of ports 24
Connector type RJ-45 (See Figure 2-1 on page 2-2.)
Cable type UTP
Power over Ethernet Up to 15.4 W per powered device on all 24 ports
(to a 312 W total on the Catalyst 4006)
113138