User's Manual

Installing Blank Faceplates over Empty HWIC Slots
68
Installing Interface Cards in Cisco 3800 Series Routers
OL-5974-01
To install blank faceplates over empty HWIC slots, follow these procedures:
• Single-wide slot—Attach a blank faceplate and tighten the two screws, using a number 1 Phillips
screwdriver.
• Double-wide slot—Install a slot divider as described in the “Installing and Removing Slot Dividers”
section on page 62. Then install two blank faceplates and tighten the two screws in each blank
faceplate.
Tip Save blank faceplates for future use.