User's Manual

23
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
OL-5792-04
Installing and Removing AIMs
Step 1 Locate the AIM connector.
Step 2 Remove the three screws from the system board near the AIM connector that you are going to use.
(
Figure 22 shows the screws to remove for AIM installation in AIM slot 1.)
Figure 22 Removing Screws from System Board—AIM Slot 1 Installation Shown
Step 3 Install the two metal standoffs (included in the accessory kit) in place of the two screws that are labeled
A in
Figure 22. Use a 1/4-inch nut driver to tighten the standoffs. (See Figure 24.)
Step 4 For most AIMs, install the plastic standoff (Figure 23)) in place of the screw that is labeled B in
Figure 22. Tighten it firmly with your fingers, or very carefully using a 3/16-inch open-end wrench. The
shoulder must be seated tight against the system board. (See Figure 24.)
A Metal standoff locations B Plastic standoff location
72107
AIM slot 1
connector
AIM slot 0
connector
System board
A
A
A
A
B
B