Network Router User Manual

BootROM Installation for Cisco 2620 and Cisco 2621 Routers

78-13192-02

Opening the Chassis

Removing the Chassis Cover

You must open the chassis to access the internal components.

Warning

Before opening the chassis, disconnect the telephone-network cables to avoid contact with

telephone-network voltages.

To remove the chassis cover:

Step 1 Attach an ESD-preventive wrist strap and ensure that it makes good contact with your skin. Connect the

equipment end of the wrist strap to the metal backplane of the chassis, avoiding contact with the

connectors.

Step 2 Power OFF the router.

Step 3 Disconnect all cables from the rear panel of the router.

Step 4 Remove the screws located on the top of the chassis. Note that the chassis is comprised of two sections:

top and bottom.

Step 5 Holding the chassis with both hands, position it as shown in Figure 1.

Step 6 Slide the top section away from the bottom section as shown in Figure 2. Set the cover aside.

Figure 1 Holding Chassis for Cover Removal

Figure 2 Removing Chassis Cover

POWER RPS ACTIVITY

H11658

Cisco 2600

SERIES

35392

POWER RPS ACTIVITY

Cisco 2600

SERIES