User Manual

Navini Networks, Inc. Ripwave-MX Modem User Guide Navini Networks, Inc. Ripwave-MX Modem User Guide
27
051123_pv1.3_Ripwave-MX Modem User Guide_40-00382-00b(prelim4.4.2)
The Indicator Light
on the Standard
External Battery
Pack (S-EBP)
Charging the
Standard External
Battery Pack (S-
EBP)
The S-EBP has one indicator light that resides on top of the unit.
This light has four states associated with it. The states are
described below.
 Light is off when any of the following apply:
• The battery is not connected to a Modem or to the battery
charger
• The battery is connected to a Modem but the Modem is off
• The battery is connected to a Modem and the Modem is on
but the battery power is depleted
 Light is green when the battery is on and fully charged.
 Light is amber when the battery has power but is no longer
fully charged. If the battery is connected to the battery charger,
an amber light means the battery is being charged.
 Light is red when the battery is low on power. When the
battery is low, it has approximately 15% of its charge left.
The S-EBP will need to be recharged when the battery is connected
to a Modem and the Modem is turned on but the LED on top of the
battery remains off (indicating the battery has no power) or is red
(indicating the battery level is low).
To recharge the S-EBP, use only the 12V charger that came with
the S-EBP. Using any other charger may damage the battery. To
charge the S-EBP, plug the 12V adapter into the 12V input socket
on the S-EBP.
NOTE: The battery may charge while it is connected to a Modem.
NOTE: Do not attempt to plug the 12V adapter into the Modem as
this may harm the Modem.
27
051123_pv1.3_Ripwave-MX Modem User Guide_40-00382-00b(prelim4.4.2)