Cable Routers Installation Guide

8-9
Cisco 1805 DOCSIS Cable Router Hardware Installation Guide
OL-14661-01
Chapter 8 Installing and Upgrading Internal Modules in Cisco 1805 Cable Routers
Modules Internal to the Cisco 1805 Cable Router
Figure 8-9 Connecting the AIM to the System Board
Step 4
Insert the connector on the AIM into the AIM connector on the system board. (See Figure 8-9.)
Note Be sure to press firmly on the AIM until the board seats onto the connector. The plastic standoff
must snap into the hole in the AIM board. (See Figure 8-9.)
Step 5 Insert the screws from the accessory kit through the AIM into the metal standoffs. (See Figure 8-9.)
Carefully tighten the screws with a Phillips screwdriver.
Step 6 Check that the AIM is installed correctly on the system board. (See Figure 8-10.)
121108
Metal standoffs
Snap-in
plastic
standoff
AIM