Computer Hardware User Manual

Installing the Traffic Slot Filler Card in the Cisco ONS 15310-CL and Cisco ONS 15310-MA

78-17422-01

Filler Card Specifications

Caution Do not operate the ONS 15310-CL or ONS 15310-MA shelf assembly unless a card is plugged into each

card slot.

The filler card is a printed circuit board (PCB) with a blank faceplate and two connectors that, when the

card is installed, plug into receptacles at the back of the slot. CTC, the ONS 15310-CL graphical user

interface (GUI), detects when a filler card is plugged in and displays it in node view.

Figure 1 shows the filler card faceplate. This card is used in the ONS 15310-CL expansion slot and ONS

15310-MA traffic card slots (Slots 1, 2, 5, and 6).

Figure 1 Filler Card

Filler Card Specifications

• Environmental

–

Operating temperature

I-Temp: -40 to +65 degrees Celsius (-40 to 149 degrees Fahrenheit)

–

Operating humidity: 5 to 95%, noncondensing

• Dimensions

–

Height: 176 mm (6.93 in.)

–

Width: 34.29 mm (1.35 in.)

–

Depth: 238.25 mm (9.38 in.)

–

Card weight (not including clam shell): 0.45 kg (0.9 lb)

Install the Filler Cards

Step 1 Open the card ejector at the top of the card.

Step 2 Slide the card along the guide rails into the expansion slot on the 15310-CL, or traffic slot on the

15310-MA (Slots 1, 2, 5, or 6).

Note Do not attempt to install the 15310-EXP-FILLER card in a CTX2500 card slot (Slots 3 and 4)

on the 15310-MA shelf assembly. Only a 15310-CTX-FILLER card should be installed in the

CTX2500 slot.

131669