Quick Start Guide I N S TA L L I N G Y O U R C I S C O 1417 R O U T E R Internet PC PC PC PC Server Server ADSL connection PC Hub PC Cisco 1407/1417 1 UNPACK THE BOX 2 INSTALL THE ROUTER 3 VERIFY YOUR INSTALLATION
Unpack the Box When you unpack the box that contains your Cisco 1417 router, you should find the items shown below. If you did not receive everything shown here, contact your Cisco reseller.
Install the Router A. Connect the router to the local network Use the included yellow Ethernet cable for connecting the router to the local Ethernet network. For more information on this cable, refer to the “Cabling Specifications” chapter in the hardware installation guide that came with the router. Step 1 Connect one end of the yellow Ethernet cable to the yellow ETHERNET port. Step 2 Connect the other end to a port on the Ethernet hub or switch.
Install the Router (continued) B. Connect the router to the ADSL line Use the included purple ADSL cable for connecting the router to the ADSL line. Step 1 Connect one end of the purple cable to the purple ADSL port on the router. Step 2 Connect the other end of the purple cable to the ADSL wall jack. Note: If you are connecting the router to a POTS splitter that uses data port pins 3 and 4 for data, you should use the purple cable with the blue stripe.
Install the Router (continued) C. Connect a PC to the router To use Cisco IOS software to configure the router, it must be connected to a terminal or to a PC with terminal-emulation software. Terminal-emulation software should be configured with the following settings: 9600 baud, 8 data bits, no parity bits, and 1 stop bit. Take the following steps to connect the router to one of these devices: Step 1 Connect one end of the blue console cable (included) to the CONSOLE port on the router rear panel.
Install the Router (continued) D. Connect the power cord Step 1 Connect the power-supply cord to the power socket on the rear panel. Step 2 Connect the other end of the cord to a power outlet. Step 3 Turn on the router by pressing the power switch to the on ( | ) position. Step 4 Confirm that the router has power by checking that the PWR LED on the front panel is on.
Verify Your Installation. After the router is powered up, the following LEDs confirm that you have correctly installed your router. LED Location What to Look for PWR Front On when power is being supplied to the router. OK Front • One blink per second when the router is in ROM monitor mode. • Several blinks per second when the router is running the boot image in ROM monitor. • On steady when the Cisco IOS software is loaded and functional.
Corporate Headquarters Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 USA http://www.cisco.com Tel: 408 526-4000 800 553-NETS (6387) Fax: 408 526-4100 European Headquarters Cisco Systems Europe s.a.r.l. Parc Evolic, Batiment L1/L2 16 Avenue du Quebec Villebon, BP 706 91961 Courtaboeuf Cedex France http://www-europe.cisco.com Tel: 33 1 6918 61 00 Fax: 33 1 6928 83 26 Americas Headquarters Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 USA http://www.cisco.
