ATM Line Card Installation and Configuration

OL-13004-01

Line Card Memory

Step 5 Remove the SODIMM0:

a. Insert a DIMM removal tool

between the SODIMM and release latch on each side of SODIMM0.

b. Gently move the tools in an outward direction to open the latches and release the module (see

Figure 25).

Caution Some SODIMM sockets use a plastic latch which is enclosed by the metal strain-relief latch. The plastic

latch should never be moved past the metal strain-relief latch.

Caution On 4-port OC-3c/STM-1 ISE and 4-port OC-12c/STM-4c ISE line cards, you must restrain SODIMM0

as it is released so it does not hit the daughtercard board.

Figure 25 Using the DIMM Removal Tools to Release the SODIMM

1. DIMM removal tools can be ordered from Cisco (Product ID: MEM-ISE-ATM-TOOL). There is no cost for

this tool.

158275