User's Guide

3-99
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14947-01
Chapter 3 Configuring Devices
Using the Templates
Table 3-29 Server-Based Security Settings
Field Description
802.1X Protocol Version (For
EAP Authentication)
Note This setting may cause the device to
reboot.
From the list, select one of the following:
• Draft 7—No radio firmware versions
compliant with Draft 7 have LEAP
capability, so you should not need to
select this setting.
• Draft 8—Select this option if
LEAP-enabled client devices that
associate with this access point use radio
firmware versions 4.13, 4.16, or 4.23, or
if workgroup bridges associating with
this access point use firmware version
8.58 or earlier.
• Draft 10—Select this option if client
devices that associate with this access
point or bridge use Microsoft Windows
XP EAP authentication, if
LEAP-enabled client devices that
associate with this bridge use radio
firmware version 4.25 or later, or if
workgroup bridges associating with this
access point use firmware version 8.65
or later.
Click * (asterisk) for information on which
version this setting is valid
Primary Server Reattempt Period
(Min)
Enter the amount of time a before another
attempt is made if the server is not
responding.
Click * (asterisk) for information on which
version this setting is valid.
Server Name/IP Enter the name or IP address of the server.