User Manual

CISCO CONFIDENTIAL - Draft 2
3-4
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-01
Chapter 3 Configuring the Access Point for the First Time
Assigning Basic Settings
Tip If your serial cable enters from the lower cable bay area, you should loop the cable as shown in
Figure 2-14.
Figure 3-1 shows the console port location.
Figure 3-1 Console Port Location
Note The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200. Browse to
http://www.cisco.com/go/marketplace to order a serial cable.
Step 3 Set up a terminal emulator on your PC to communicate with the access point. Use the following settings
for the terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
Assigning Basic Settings
After you determine or assign the access point’s IP address, you can browse to the access point’s Express
Setup page and perform an initial configuration:
Step 1 Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later) or Netscape
Navigator (version 4.x).
Step 2 Enter the access point’s IP address in the browser address line and press Enter. An Enter Network
Password screen appears.
Step 3 Press Tab to bypass the Username field and advance to the Password field.
Step 4 Enter the case-sensitive password Cisco and press Enter. The Summary Status page appears.
1 Console port