User Manual
Table Of Contents
- Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Safety Information
- Warnings
- Unpacking the Access Point
- Basic Installation Guidelines
- Before Beginning the Installation
- Installation Summary
- Opening the Access Point Cover
- Mounting the Access Point
- Mounting Above a Suspended Ceiling
- Attaching the Access Point to the Mounting Plate
- Connecting the Ethernet and Power Cables
- Securing the Access Point
- Powering Up the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Power Levels
- Console Cable Pinouts
- Glossary
- Index
CHAPTER
CISCO CONFIDENTIAL - Draft 2
3-1
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-01
3
Configuring the Access Point for the First Time
This chapter describes how to configure basic settings on your access point for the first time. The
contents of this chapter are similar to the instructions in the quick start guide that shipped with your
access point. You can configure all the settings described in this chapter using the CLI, but it might be
simplest to browse to the access point’s web-browser interface to complete the initial configuration and
then use the CLI to enter additional settings for a more detailed configuration.
This chapter contains these sections:
• Before You Start, page 3-2
• Obtaining and Assigning an IP Address, page 3-3
• Connecting to the Access Point Locally, page 3-3
• Assigning Basic Settings, page 3-4
• Protecting Your Wireless LAN, page 3-9
• Using the IP Setup Utility, page 3-9
• Assigning an IP Address Using the CLI, page 3-11
• Using a Telnet Session to Access the CLI, page 3-11