User Manual
Table Of Contents
- Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Safety Information
- Warnings
- Unpacking the Access Point
- Basic Installation Guidelines
- Before Beginning the Installation
- Installation Summary
- Opening the Access Point Cover
- Mounting the Access Point
- Mounting Above a Suspended Ceiling
- Attaching the Access Point to the Mounting Plate
- Connecting the Ethernet and Power Cables
- Securing the Access Point
- Powering Up the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Power Levels
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
2-20
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-01
Chapter 2 Installing the Access Point
Securing the Access Point
Securing the Access Point to the Mounting Plate
The mounting plate contains a security padlock hole and a security screw hole to enable you to secure
your access point to the mounting plate to restrict it’s removal. You can use a security-type screw (that
you provide) to attach the access point to the mounting plate using the security screw hole (see
Figure 2-12).
Note Using a security-type screw to secure the access point to the mounting plate does not prevent someone
from inserting or removing the access point cables or pressing the mode button.
You can use the security hasp adapter (supplied) and a padlock (that you provide) to secure your access
point to the mounting plate. Compatible padlocks are Master Lock models 120T or 121T.
Note The security hasp adapter covers the cable bay area (including the power port, Ethernet port, console
port, and the mode button) to prevent the installation or removal of the cables or the activation of the
mode button.
Follow these instructions to install the security hasp adapter:
Step 1 Open the access point cover (see the “Opening the Access Point Cover” section on page 2-8).
Step 2 Carefully insert the access point security hasp tab into the notch on the security hasp adapter (see
Figure 2-15).
Figure 2-15 Installing the Security Hasp Adapter
Step 3
Push down on the security hasp adapter to ensure the padlock hole is not blocked.
Step 4 Insert a padlock into the padlock hole and lock the padlock.
1 Access point security hasp tab 3 Security hasp adapter
2 Security hasp notch