User Manual
Table Of Contents
- Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Safety Information
- Warnings
- Unpacking the Access Point
- Basic Installation Guidelines
- Before Beginning the Installation
- Installation Summary
- Opening the Access Point Cover
- Mounting the Access Point
- Mounting Above a Suspended Ceiling
- Attaching the Access Point to the Mounting Plate
- Connecting the Ethernet and Power Cables
- Securing the Access Point
- Powering Up the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Power Levels
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
Contents
iv
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-01
Installing the Access Point 2-1
Safety Information 2-2
FCC Safety Compliance Statement 2-2
General Safety Guidelines 2-2
Warnings 2-2
Unpacking the Access Point 2-3
Package Contents 2-3
Basic Installation Guidelines 2-3
Before Beginning the Installation 2-4
Access Point Layout and Connectors 2-4
Mounting Plate 2-5
Suspended Ceiling Adjustable T-Rail Clips 2-6
Installation Summary 2-7
Opening the Access Point Cover 2-8
Mounting the Access Point 2-9
Mounting on a Horizontal or Vertical Surface 2-10
Mounting Below a Suspended Ceiling 2-11
Mounting Above a Suspended Ceiling 2-13
Mounting on a Network Cable Box 2-14
Mounting on a Desktop or Shelf 2-15
Rotating the Cisco Logo 2-15
Attaching the Access Point to the Mounting Plate 2-16
Connecting the Ethernet and Power Cables 2-17
Connecting to an Ethernet Network with an Inline Power Source 2-18
Connecting to an Ethernet Network with Local Power 2-19
Securing the Access Point 2-19
Using a Security Cable 2-19
Securing the Access Point to the Mounting Plate 2-20
Powering Up the Access Point 2-21
Configuring the Access Point for the First Time 3-1
Before You Start 3-2
Resetting the Access Point to Default Settings 3-2
Using the Mode Button 3-2
Using the Web-Browser Interface 3-2
Obtaining and Assigning an IP Address 3-3
Connecting to the Access Point Locally 3-3
Assigning Basic Settings 3-4