User Manual
Table Of Contents
- Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Safety Information
- Warnings
- Unpacking the Access Point
- Basic Installation Guidelines
- Before Beginning the Installation
- Installation Summary
- Opening the Access Point Cover
- Mounting the Access Point
- Mounting Above a Suspended Ceiling
- Attaching the Access Point to the Mounting Plate
- Connecting the Ethernet and Power Cables
- Securing the Access Point
- Powering Up the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Power Levels
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
2-11
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-01
Chapter 2 Installing the Access Point
Mounting the Access Point
Step 5 Position the mounting plate over the wall anchors or the drilled holes.
Step 6 Insert two 8x32x1inch pan head screws in the X mounting holes and tightening.
To attach the access point to the mounting plate, see “Attaching the Access Point to the Mounting Plate”
section on page 2-16.
Mounting Below a Suspended Ceiling
You should review Figure 2-8 before beginning the mounting process.
Figure 2-8 Adjustable T-Rail Clips
Follow these steps to mount your access point on a suspended ceiling:
Step 1 Decide where you want to mount the access point on your suspended ceiling.
Step 2 Select the appropriate adjustable T-rail clip for your suspended ceiling and open the clip to the maximum
(see Figure 2-4).
Step 3 Unscrew the two T-rail locking set screws to enable placing the clip over a T-rail.
1 T-rail locking set screw 3 T-rail width detents (A, B, or C)
2 Mounting plate screw holes