User Manual
Table Of Contents
- Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Safety Information
- Warnings
- Unpacking the Access Point
- Basic Installation Guidelines
- Before Beginning the Installation
- Installation Summary
- Opening the Access Point Cover
- Mounting the Access Point
- Mounting Above a Suspended Ceiling
- Attaching the Access Point to the Mounting Plate
- Connecting the Ethernet and Power Cables
- Securing the Access Point
- Powering Up the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Power Levels
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
2-9
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-01
Chapter 2 Installing the Access Point
Mounting the Access Point
Step 3 Continue to slowly slide the cover back across the access point until you reach the cover stop (see
Figure 2-6).
Figure 2-6 Opening the Access Point Cover
Mounting the Access Point
This section describes the steps necessary to mount the access point using thesemethods:
• Horizontal or vertical surface—see the “Mounting on a Horizontal or Vertical Surface” section on
page 2-10
• Under a suspended ceiling—“Mounting Below a Suspended Ceiling” section on page 2-11
• Network cable box—“Mounting on a Network Cable Box” section on page 2-14
• Desktop or shelf—see the “Mounting on a Desktop or Shelf” section on page 2-15
1 Access point cover (maximum open position) 3 Opening direction
2 Cable bay area 4 Cable opening (in access point housing)