User Manual
Table Of Contents
- Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Safety Information
- Warnings
- Unpacking the Access Point
- Basic Installation Guidelines
- Before Beginning the Installation
- Installation Summary
- Opening the Access Point Cover
- Mounting the Access Point
- Mounting Above a Suspended Ceiling
- Attaching the Access Point to the Mounting Plate
- Connecting the Ethernet and Power Cables
- Securing the Access Point
- Powering Up the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Power Levels
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
1-4
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-01
Chapter 1 Overview
Hardware Features
Power Sources
The access point can receive power from an external power module (supplied)or from inline power using
the Ethernet cable. The access point supports the IEEE 802.3af inline power standard and the Cisco CDP
Power Negotiation protocol. Using inline power, you do not need to run a power cord to the access point
because power is supplied over the Ethernet cable.
Warning
This product must be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source or an
IEC60950 compliant limited power source.
The access point supports the following power sources:
• Power module (supplied)
• Inline power:
–
Cisco Aironet Power Injector (AIR-PWRINJ3 or AIR-PWRINJ-FIB)
–
An inline power capable switch, such as the Cisco Catalyst 3524 PWR XL, 3560-48PS,
3570-48PS, 4500 with 802.3AF PoE module, or the 6500 with 802.3AF PoE module
–
Other inline power switches supporting the IEEE 802.3af inline power standard
Note Some switches and patch panels might not provide enough power to operate the access point when
configured with both 2.4-GHz and 5-GHz radios. On power-up if the access point is unable to determine
that the power source can supply sufficient power, the access point automatically deactivates both radios
to prevent an over-current condition. The access point also activates a Status LED low power error
indication and creates an error log entry (refer to the “Checking the Access Point LEDs” section on
page 6-2 and the “Low Power Condition” section on page 6-5).
Anti-Theft Features
There are three methods of securing the access point to help prevent theft:
• Security cable keyhole—You can use the security cable slot to secure the access point using a
standard security cable, such as those used on laptop computers.
• Security hasp adapter—When you mount the access point on a wall or ceiling using the mounting
plate and the security hasp, you can lock the access point to the plate with a padlock (see Figure 1-2).
Compatible padlocks are Master Lock models 120T and 121T or equivalent.
Note The security hasp adapter covers the cable bay area ( including the power port, Ethernet port,
console port, and the mode button) to prevent the installation or removal of the cables or the
activation of the mode button.