User Manual
Table Of Contents
- Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Safety Information
- Warnings
- Unpacking the Access Point
- Basic Installation Guidelines
- Before Beginning the Installation
- Installation Summary
- Opening the Access Point Cover
- Mounting the Access Point
- Mounting Above a Suspended Ceiling
- Attaching the Access Point to the Mounting Plate
- Connecting the Ethernet and Power Cables
- Securing the Access Point
- Powering Up the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Power Levels
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
1-2
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-01
Chapter 1 Overview
Hardware Features
Hardware Features
This section describes access point features. Refer to Appendix C, “Access Point Specifications,” for a
list of access point specifications.
Key hardware features of the access point include:
• Dual-radio operation (see page 1-2)
• Ethernet port (see page 1-3)
• Console port (see page 1-3)
• LEDs, (see page 1-3)
• Power sources (see page 1-4)
• Anti-theft features (see page 1-4)
• UL 2043 certification (see page 1-6)
Figure 1-1 shows the access point hardware features.
Figure 1-1 Access Point Hardware Features
Dual-Radio Operation
The access point supports simultaneous radio operation using a 2.4-GHz 802.11g radio and a 5-GHz
802.11a radio. Each radio uses 2-dBi dual-diversity integrated antennas.
The 5-GHz radio incorporates an Unlicensed National Information Infrastructure (UNII) radio
transceiver operating in the UNII 5-GHz frequency bands. The 802.11g radio is called Radio0 and the
802.11a radio is called Radio1.
1 Status LED 5 Console port (RJ-45)
2 48-VDC power port 6 Mode button
3 Ethernet port (RJ-45) 7 Ethernet and Radio LEDs
4 Keyhole slot