User Manual
Table Of Contents
- Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Safety Information
- Warnings
- Unpacking the Access Point
- Basic Installation Guidelines
- Before Beginning the Installation
- Installation Summary
- Opening the Access Point Cover
- Mounting the Access Point
- Mounting Above a Suspended Ceiling
- Attaching the Access Point to the Mounting Plate
- Connecting the Ethernet and Power Cables
- Securing the Access Point
- Powering Up the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Power Levels
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
C-1
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-01
APPENDIX
C
Access Point Specifications
This appendix provides technical specifications for the Cisco Aironet 1130AG Series Access Point.
Table C-1 lists the technical specifications for the access point.
Table C-1 Access Point Specifications
Category 802.11b Radio Specifications 802.11g Radio Specifications 802.11a Radio Specifications
Size 7.53 in. W x 7.53 in. D x 1.31 in. H
19.13 cm W x 19.13 cm D x 3.33 cm H
Indicators Tri-color Status LED indicator on the top panel and two bi-color LED indicators (radio and Ethernet)
in the cable bay
Connectors Cable bay (left to right)
Power connector (for plug-in AC power module); RJ-45 connector for 10BASE-T or
100BASE-T Ethernet connections; upside down RJ-45 connector for serial connections.
Input Voltage 48 VDC (nominal)
Input Power 12.95 W (typical)
Operating Temperature Base unit:
32 to 104
o
F (0 to 40
o
C)
1130 series power injector:
32 to 104
o
F (0 to 40
o
C)
1130 series power module:
32 to 104
o
F (0 to 40
o
C)
Storage Temperature TBD to TBD
o
F (TBD to TBD
o
C)
Weight Without mounting hardware:
1.48 lbs (0.67 kg)