Network Router User Manual

3-29

Cisco 2600 Series Routers Hardware Installation Guide

OL-2171-06

Chapter 3 Installing the Router

Configuring the Router

Would you like to enter the initial configuration dialog? [yes/no]:

Note If these messages do not appear, SDM and a default configuration file have been installed on the router

at the factory. To use SDM to configure the router, refer to the quick start guide that shipped with your

router. You can also access the Cisco2600 series routers quick start guides online at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/26xx_qsg/index.htm

Note To avoid losing work you have completed, be sure to save your configuration occasionally as you

proceed. Use the copy running-config startup-config command to save the configuration to NVRAM.

Step 1 To proceed with manual configuration using the CLI, enter no:

Would you like to enter the initial configuration dialog? [yes/no]: no

Step 2 Press Return to terminate autoinstall and continue with manual configuration:

Would you like to terminate autoinstall? [yes] Return

Several messages are displayed, ending with a line similar to the following:

...

Compiled <

date

> <

time

> by <

person

Step 3 Press Return to bring up the Router> prompt:

...

flashfs[4]: Initialization complete.

Router>

Step 4 Enter privileged EXEC mode:

Router> enable

Router#

For configuration using the CLI, refer to the Software Configuration Guide for Cisco 2600 Series,

Cisco 3600 Series, and Cisco 3700 Series Routers. or the Cisco IOS software configuration

documentation. You can access these documents on Cisco.com and on the Documentation CD-ROM.