Network Router User Manual

Contents
v
Cisco 2600 Series Routers Hardware Installation Guide
OL-2171-06
Connecting Routers to AC Power 3-15
Connecting Routers to a DC-Input Power Supply 3-16
DC Wiring Requirements 3-16
Connecting Routers to the Cisco Redundant Power System 3-18
Connecting WAN, LAN, and Voice Cables 3-18
Ports and Cabling 3-18
LAN, WAN, and Voice Connection Procedures 3-19
Connecting to a Console Terminal or Modem 3-20
Connecting to the Console Port 3-20
Connecting to the Auxiliary Port 3-21
Identifying a Rollover Cable 3-22
Powering Up the Router 3-23
Checklist for Power Up 3-23
Front Panel Indicators 3-23
Power-Up Procedure 3-24
Configuring the Router 3-25
Initial Configuration Using SDM 3-26
Initial Configuration Using the Setup Command Facility 3-26
Initial Configuration Using the CLI (Manual Configuration) 3-28
APPENDIX A Troubleshooting A-1
Isolating Problems A-1
Troubleshooting the Power and Cooling Systems A-2
Environmental Reporting Features A-2
Troubleshooting Modules, Cables, and Connections A-3
System Messages A-4
Recovering a Lost Password A-4
Cisco Technical Assistance Center A-4
APPENDIX B Using the ROM Monitor B-1
Entering ROM Monitor Mode B-1
ROM Monitor Commands B-2
ROM Monitor Command Syntax Conventions B-3
ROM Monitor Command Descriptions B-4
Router Management Commands B-4
Boot Commands in the ROM Monitor B-4
Informational Commands in the ROM Monitor B-5
Other Useful ROM Monitor Commands B-6