User's Manual
Table Of Contents
- Fast Start Guide
- User Guide (English only)
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Connecting the Router
- Chapter 3: Configuring the PCs
- Chapter 4: Configuring the Router
- Chapter 5: Using the Router's Web-Based Utility
- Appendix A: Troubleshooting
- Appendix B: How to Ping Your ISP's E-mail and Web Addresses
- Appendix C: Configuring Wireless Security
- Appendix D: Finding the MAC Address and IP Address for Your Ethernet Adapter
- Appendix E: Setting Up AOL Broadband Cable & DSL
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Contact Information
- Appendix I: Warranty Information
• Using Multicast Pass Through
This feature allows for multiple transmissions to specific recipients at the
same time. Select Enable to support the feature, or Disable to keep the
Router from multicasting.
• Using IPSec Pass Through
This feature lets you use IPSec Pass Through. To use this feature, click the
Enable button next to IPSec Pass Through, and then the Apply button.
IPSec Pass Through is enabled by default. To disable IPSec Pass Through,
click on Disable and then the Apply button.
• Using PPTP Pass Through
Point-to-Point Tunneling Protocol is the method used to enable VPN
sessions. To enable this feature, click the Enable button next to PPTP Pass
Through, and click the Apply button.
PPTP Pass Through is enabled by default. To disable this feature, click on
Disable next to PPTP Pass Through, and then the Apply button.
• Using Remote Management
This feature allows you to manage the Router from a remote location, such
as over the Internet. To enable this feature, click on Enable, and click the
Apply button. Remote Management must be activated before you can man-
age the Router from a remote location.
To disable Remote Management, click on Disable, and click the Apply but-
ton. If you wish to use this feature, enter http:\\<WAN IP Address>:8080
into your web browser’s address field and press the Enter key. (Enter your
specific WAN IP Address in place of <WAN IP Address>.)
To disable this feature, click on Disable, and click the Apply button.
• Using Remote Upgrade
This feature allows you to upgrade the Router’s firmware from a remote
location. To enable Remote Upgrade, click on Enable, and then click the
Apply button. Remote Management must be activated before you can man-
age the Router from a remote location.
• Using MTU (Maximum Transmission Unit)
This feature specifies the largest packet size permitted for network trans-
mission. Select Enable and enter the value desired. It is recommended that
you leave this value in the 1200 to 1500 range. For most DSLusers, it is
recommended to use the value 1492. By default, MTU is set at 1500 when
disabled.
Important: Upgrading may cause the
Router to be reset to the factory
defaults. Make a record of all set-
tings before attempting the upgrade.
Instant Wireless
TM
Series Wireless Access Point Router with 4-Port Switch
39 40